DISCLAIMER

All rights of photos and text reserved. Usage of photos or text from my blog on other websites or for any other purpose only with prior permission. If you want to use any material from my blog please contact me by email.

Monday, May 27, 2013

ELROG 211 and 845 tubes now available

Hi!

The first shipment of ELROG tubes arrived today.





The tubes are nicely packaged as matched pairs. A measurement certificate signed by Dr. Schaffernicht  comes with each pair:




Each tube has it's individual serial number, stamped on a metal plate inside the glass:




Craftsmanship is exceptional. The plates always have the same alignment with regard to the pins, which is not always the case with NOS tubes.

A NOS GE211 / VT4C in comparison to a ER211:




They are about the same height. The ELROGs have a slightly larger diameter. Earlier ELROGs had a smaller diameter glass. This was changed for the final series production to give better heat dissipation. The most apparent difference is the location of the electrode system. While the system is mounted in the upper half of the tube in the GE. ELROG mounts the system close to the base, which gives  much shorter wire lengths between bins and electrodes.

I ran some measurements on a curve tracer. Comparing a NOS GE211 with ELROG. Unfortunately my tracer only allows plate voltages up to 400V.

Here is the set of plate curves of the GE:




On the X axis the scale is 50V per division. On the Y axis we have 2.5mA per division. The grid steps is 5V, starting with 0V with the left most grid line.

The ER211 in comparison:




Remember this is only up to 400V and 20mA. These curves show why these DHTs are so great. They are exceptionally linear. The ELROG is remarkably close to the GE the grid lines are a little bit steeper with the ER211 indicating slightly better transconductance.

The tubes will be tried in various amplifiers and I will provide feedback on the sound. Stay tuned!

Send an email to thomas -at- vinylsavor -dot- de for inquiries about these tubes.

Best regards

Thomas

3 comments:

  1. Hallo,

    ich habe nun die ELROGs 211 im Einsatz. Zunächst zur Geräteschaft. Die Röhren laufen in Bausätzen von Thomas (801A auf 211) mit den Tangos als Zwischen- und Ausgangsübertrager. Auch die Vorstufen sind nach von mir gelötet nach Bausatz von Thomas.
    Bis dato hatte ich als 211 zunächst die GE und dann als Steigerung die United.

    Zu den ELROGs:

    Nach einer Phase der Eingewöhnung war das erste Erlebnis, dass meine Liebste den Raum betrat (und eigentlich mit HiFi nur durch mich etwas zu tun hat) und sagte, oh! die Musik lebt jetzt.

    Ich muss gar nicht lange herumreden! Die ELROGs 211 klingen für mich folgendemaßen:

    Die Schönheit der 45
    Die Magie der 300B
    Die Kraft der 211/845

    Es ist unglaublich. Ich habe die Teströhren sofort gekauft! Und ich muss gestehen, ich hätte auch gerne die anderen Röhren von ELROG - wenn sie sich dann so verbessern.

    Danke Thomas, für diese 1A Röhren. Sie sind jeden Cent wert!

    ReplyDelete
  2. What is the Bias level iñ MA on the grid of the 211

    ReplyDelete
    Replies
    1. That depends on which bias you set. Bias should always be set according to the tube amp requirements, not the tube

      Delete